Audio Tech 462Z Instrucciones de operaciones Pagina 2

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 10
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 1
OPERATING INSTRUCTIONS
RADIO INTERCOM SYSTEM
MODEL 462, 462X and 462Z
The new Model 462 combination AM-FM Radio, and Intercom System with built-
in Door Chimes is a sophisticated state of the art home entertainment and com-
munications system that is easy to operate by everyone in the family. The 462X
has built-in station tuning, and the 462Z also has a home automation relay that
can be used to release a door lock. To enjoy the many features of the system
you must read these instructions. Keep this booklet in a handy place for refer-
ence to help you perform the less frequently used functions.
SOME HELPFUL SUGGESTIONS
1. This radio and intercom is a System that consists of Room/Patio speakers
plus door entry speakers that activate the Westminster Chime. For best perfor-
mance and quality of audio you must properly adjust two (2) separate volume
controls that regulate the volume of any room speaker.
A. The main volume control is on the Master Unit and is labeled Intercom.
This control regulates the maximum loudness of volume that will be received at
all the room speakers. This volume control should always be adjusted to a level
slightly louder than your comfort level. Be sure to make this adjustment with the
SPEAKER volume control fully clockwise (full on); after the intercom adjustment
is made, the SPEAKER control can be rotated back slightly to reduce the vol-
ume to a comfortable level.
B. Every room station has a secondary volume control. This volume control
should be used slightly below Full-On to reduce the volume level at the speaker
for individual comfort. Remember, set the Master Unit slightly louder than nor-
mal, and adjust the individual Room speaker a little from Full-On to the lower
comfort level.
Do not turn the INTERCOM control on the Master Unit to an unnecessarily high
(loud) setting. This can cause the amplifier to go into distortion. Do not try to
correct distortion by just lowering the volume at the room station; instead, lower
the intercom volume control on the master.
* * * * * * * *
Vista de pagina 1
1 2 3 4 5 6 7 8 9 10

Comentarios a estos manuales

Sin comentarios